point-to-multipoint frame relay switching configuration example

[folderman]

hi all,

i would like to know how to configure a frame-relay switch so that i can test point-to-multipoint frame-relay? thanks!

i am using a 2500 series with 4 serial interfaces as the switch.

[thisisshanky]

Assume a hub with three pvcs to three remote sites. From the hub side it appears to have a multipoint interface with multiple pvcs. From the spoke side, each pvc is a point-to-point config.

Here is a sample config

frame-relay switching

int s0

frame-relay intf-type dce

frame-relay route 102 int s1 201

frame-relay route 103 int s2 301

frame-relay route 104 int s3 401

int s1

frame-relay intf-type dce

frame-relay route 201 int s0 102

int s2

frame-relay intf-type dce

frame-relay route 301 int s0 103

int s3

frame-relay intf-type dce

frame-relay route 401 int s0 104

[folderman]

i think that's what i need. let me try. thx

[Kevin Dorrell]

Do you mean the use of multiple map commands on a Serial interface? If so, this document has an example:

http://www.cisco.com/warp/public/125/15.pdf

Here are some documents about setting up your switch:

http://www.cisco.com/warp/public/125/fr_switching.pdf

http://www.cisco.com/en/US/tech/tk713/tk237/technologies_configuration_example09186a0080094a3c.shtml

This document has loads of goodstuff about configuring Frame Relay:

http://www.cisco.com/en/US/tech/tk713/tk237/technologies_tech_note09186a008014f8a7.shtml#hubnspoketop3

In fact, here is a useful list of resources:

http://www.cisco.com/en/US/tech/tk713/tk237/tech_configuration_examples_list.html

Hope it helps

Kevin Dorrell

Luxembourg

[folderman]

hi kevin,

thanks very much for your links, it is helpful to me.