Routing

Hello All:This is kind of a followup of a post I made last week. I have 3 T's that I load balanced using IP CEF on my side ...just needed it outbound. Worked like a charm....load wise. All traffic appears spread evenly across the 3 t's.What I have no...

There are lot of difference between PPP and HDLC which arises lot of questions. The following are some genric diffrences between HDLC and PPP are:HDLC1.It is vendor specific.2.It doesn’t support authentication.3.It supports synchronous network only.4...

hello,we've got an installation at a customer with two sites connected via a 1Mbit/sec serial link using llq for voice priorisation. after having problems with the voice quality and debugging around i a get very interesting output when using the "deb...

Hi,We have two 2621 Routers (R1, R2) connected back to back through Ethernet interface, all our clients should be routed from R1 to R2 with different ip address, so we've created a subinterface for each client on both routers and we have used Policy ...

I have a router 2821 with two interfaces Ethernet connected to two routers ADSL connected to Internet and a card VIC of four ports connected to the Lan I need a configuration type of this case.Some users have to go out to Internet for a connection AD...

This is Nilesh, from India,mumbai. Working as Network Engineer for Birlasunlife Insurance Co.Ltd,Here in my network i got Two 2610 Xm series router, where first rouer is myProduction router and another one is standby.so there are three 2 mbps links o...

Hi,I have configured HSRP on my core switches, Cisco 4006,and is working fine, standby taking the role of active is fine without much delay, but as soon as the active is restored there is a delay in time for the standby to recogonise the active ,pls ...

does anyone know of any step-by-step instructions on how to configure a cisco catalyst 3560 and 3750 switch with VLAN's and also cisco 2800 and 3800 series routers....for both across the wan and the lan?I just want to know what each line by line conf...

Hi,i would like to know if a cisco 1801 or 1811 can supports à lease line à 256 kbits/s ?And what kind of Wan card do I need?Regards

Hello All:Was wondering if this is possible. Can you force specific servers/clients to route out a specific serial interface.I have 1 router, 3 T1's connected to 3 serial interfaces. NatClient A - 10.0.2.2Client B - 10.0.2.3Client C - 10.0.2.4Can I f...

Hi GuysI have a Cisco SOHO 97 router which is working fine, I dont want to touch it. However, Cisco tech help is mega expensive and I cant afford to pay for the config of another one I have to buy.The config is not a standard IOS interface config and...

Virtual Private Networks Forum Log In |Bookmarks |My NetPro |Subscriptions |Web Digest Forum Topics > Conversations > Outline > Messages < Previous Conversation | Next Conversation > General Need Help - NAT Configuration atanda - , Lucent Te...

This is a sort of generalised question. Someone has asked, and am actually scratching my head thinking that he has the wrong end of the stick entirely and I want to put him straight.The sceanrio is:we are going over to another ISP for our Internet/si...