Policy Based Routing by MAC on RV345?

[JefferyMiller17244]

Hello,

I recently made the switch from Peplink Balance 20 to Cisco RV345. On the Peplink I could do Policy Based Routing by MAC address and force certain machines through a specific WAN. On the RV345 I only seem to be able to do this by IP address. Is this true? This seems like a very limited way to do this type of routing because if the IP address changes, via DHCP, then it is going to break the Policy Based Routing rule for that machine.

What am I missing... or is IP really the only way that I can do Policy Based Routing?

Thanks,

Jeff

[Georg Pauwen · Accepted solution]

Hello,

unfortunately, policy routing on the RV345 supports only IP source and destination, nothing MAC based. The RV345 does not feature a full IOS, but rather a stripped down version.

[JefferyMiller17244]

Thanks, @Georg Pauwen