Policy Based Routing Help.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2018 11:14 AM - edited 03-05-2019 09:48 AM
Getting error when attempting to run command..."Device(config)# route-map pbr-map permit" Getting "Invalid Input detected at '^' marker
I can run this command on my Cisco Catalyst 3850-XS 10g SPF Switch but not my Cisco Catalyst 2960-X.
Looking for so insight on this issue.
Thanks.
~ Jerry
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2018 11:30 AM
it's possible you need to change the sdm template that the switch is using. Try "sdm prefer routing" on global configuration mode
regards

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2018 11:17 PM
Catalyst 2960-x has 3 feature sets -
IP Lite (Layer 3) | LAN Base (Layer 2) | LAN Lite (Basic Layer 2) |
What is feature set on you catalyst ?
