cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
365
Views
0
Helpful
1
Replies

PPP configuration pt

master_120001
Level 1
Level 1

I'm following a ppp tutorial and it's all good but theres is one issue my serial interfaces protocols are down, I don't understand why

as shown below the issue is serial 2

Router 2#sho ip int brief

Interface IP-Address OK? Method Status Protocol


Interface              IP-Address      OK? Method Status                Protocol
 
FastEthernet0/0        unassigned      YES DHCP   up                    up
 
FastEthernet0/1        1.1.1.1         YES manual up                    down
 
Serial0/2/0            10.0.0.2        YES manual up                    down
 
Serial0/2/1            unassigned      YES unset  up                    up
 
Vlan1                  unassigned      YES unset  administratively down down

------------------------------------------------------------------------------------

 I'm also getting this repeat message 


Serial0/2/0 IPCP: I CONFREQ [Closed] id 1 len 10

Serial0/2/0 IPCP: O CONFACK [Closed] id 1 len 10

Serial0/2/0 IPCP: O CONFREQ [Closed] id 1 len 10

Serial0/2/0 IPCP: I CONFACK [Closed] id 1 len 10

 

1 Reply 1

Vinit Jain
Cisco Employee
Cisco Employee

Hello,

Could you share the running config from both the routers in a file along with the debug ppp negotiation output.

Thanks

 

Thanks
--Vinit