Why does the Dialer interface show LCP as closed, but on the Virtual-Access interface LCP shows up as open?
Also, is it normal for the NCPs to only show up under the Virtual-Access interface? What is the reasoning for this?
sh int di1 Dialer1 is up, line protocol is up (spoofing) Hardware is Unknown Description: PPPOE LINK Internet address is <REDACTED> MTU 1492 bytes, BW 56 Kbit/sec, DLY 20000 usec, reliability 255/255, txload 104/255, rxload 255/255 Encapsulation PPP, LCP Closed, loopback not set Keepalive set (10 sec) DTR is pulsed for 1 seconds on reset Interface is bound to Vi2
sh int vi2 Virtual-Access2 is up, line protocol is up Hardware is Virtual Access interface Description: PPPOE LINK MTU 1492 bytes, BW 56 Kbit/sec, DLY 20000 usec, reliability 255/255, txload 127/255, rxload 168/255 Encapsulation PPP, LCP Open Stopped: IPV6CP Open: IPCP PPPoE vaccess, cloned from Dialer1