cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
273
Views
0
Helpful
1
Replies

Problem establishing link between 2 sites over MPLS service provider

My setup is as shown in the figure below:

https://www.dropbox.com/s/rnaohtgi0h9uurd/dpc.jpg 

Two sites to communicate over an MPLS network. The data center already exists and was functional well before this new setup. ISP has given us VLAN ID information so we can establish link between the new site and the data center through an existing subnet. Below is the link to the configurations for the new site:

https://www.dropbox.com/s/4fnrdjhk9aki5m0/dpc%20router.txt

I have done some troubleshooting, see links below:

https://www.dropbox.com/s/heoosjwf2hz9isz/sh%20ip%20route.txt

https://www.dropbox.com/s/gex5uxo5jrxc0lj/sh%20ip%20int%20br.txt

 

From the new router I am failing to ping the data center router. I cannot see anthing wrong with my configuration on the new router. May you go through the config and check if I am missing something.

 

Thanks in advance

 

Kelvin 

1 Reply 1

vishal vyas
Beginner
Beginner

your configuration looks ok, if possible could you send the outpu of #show interface tunnel 22

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers