problem in cofiguring bridge domain

[Hamidreza]

Hi,

I have configured a bridge domain between two ports of router (Gi 0/1 and Gi 0/2) and also i have configured a BDI interface and assigned an IP address (192.168.1.1/24) to it. In the picture below, you can see my topology.

my problem is, the two router in below could not ping the BDI interface IP address. 

Thank you so much for your help

[Gopinath_Pigili]

 Best regards
******* If This Helps, Please Rate *******

[Hamidreza]

i've tried to configure IRB but in the interface configuration i could not find bridge group 1.

bridge irb

bridge 1 protocol vlan-bridge

bridge 1 route ip

(config)#interface gigabitEthernet 0/0/1

bridge-      <<<<<, there is not bridge command  

[MHM Cisco World]

bridge irb
bridge 100 protocol vlan-bridge <<- this must ieee not vlan-bridge 
Bridge 100 route IP  

only add this no need to change other config 

[Hamidreza]

my router has not ieee

only it has the below options

ast IBM protocol
dec DEC protocol
ibm IBM protocol
vlan-bridge vlan-bridge protocol

[MHM Cisco World]

bridge 100 protocol vlan-bridge <<- no need this command then 
try ping Now 
the VRF in Routers is not effect reachable 

[Gopinath_Pigili]

1st configure bvi 1 then assign interfaces to bvi 1

1st configure

Config)#interface bvi 1

(config-if)# ip address  ip-address subnet-mask

Then

(config)# interface Gig0/2

(config-if)# bridge-group 1

(config)# interface Gig0/1

(config-if)# bridge-group 1

Best regards
******* If This Helps, Please Rate *******