problem in table of interface

[username11]

Hi

I have a problem with the interfaces ios xr 9000 -7.4.2 the interfaces do not appear in the interface table except interface management

[balaji.bandi]

the interfaces do not appear in the interface table except interface management

because you issuing the command "show ip interface brief"

what is the output below :

show interface status

[username11]

commande show interface status don't work

[balaji.bandi]

Just to clarify - is this Physical kit or Lab virtual 

can you post - show version and show intercace brief output

[username11]

@balaji.bandi 

lab virtuel on eve-ng

[balaji.bandi]

Post-show version full output (not screenshot here) if you looking for some help:

or refer to this video :

https://www.youtube.com/watch?v=NtyGbq36y8M

[username11]

[MHM Cisco World]

...

[Harold Ritter]

Hi @username11 ,

The fact that you can't see the interfaces is due to the LC component not running, which may be caused by a lack of resources. You can see that by doing a "show platform".

You should see both the RP and LC if your XRv9k loaded normally:

RP/0/RP0/CPU0:PE1#sh platform
Fri Mar 4 14:55:34.576 UTC
Node Type State Config state
--------------------------------------------------------------------------------
0/0/CPU0 R-IOSXRV9000-LC-C IOS XR RUN NSHUT
0/RP0/CPU0 R-IOSXRV9000-RP-C(Active) IOS XR RUN NSHUT
RP/0/RP0/CPU0:PE1#

Regards,

[username11]

Hi @Harold Ritter 

it's true that LC is not load but I modify the resource of this router (19 GO Ram) and the same problem persists.

[Harold Ritter]

Hi @username11 ,

Here's the minimum required resources listed in VIRL. They should be similar then what should be used in GNS3.

Cisco IOS XRv 9000 Router platform

At a very minimum, 10 GB of DRAM and 2 vCPUs are required.
It is recommended to use 16 GB and 4 vCPUs.

How many VCPUs dis you configure?

Also, what is the network card type you specified? If you use E1000, could you try virtio instead.

Regards,

[username11]

Hello @Harold Ritter 

I work with (Ram=19GO, VCpu=4)and card is tpl(virtio-net-pci) 

[balaji.bandi]

Can you post complete boot process of IOS XR -  eve-ng running on Esxi or vmware workstation or baremetal ?

[username11]

@balaji.bandi 

baremetal

[balaji.bandi]

i do run PNET (similar to eve-ng) 16GB and 4vCPU works as expected. is this new Lab ? i would check image template content