03-22-2011 05:30 AM - edited 03-04-2019 11:49 AM
I used CCP 2.2 without problem. At now I updated to CCP 2.4. Cisco 871 still without problem but on Cisco 2811 I have a problem. CCP cannot discover it and then I cannot to login on teh router (it unrecognize user and passw). Login fail disssapears past some hours. ¿Could you help me?
03-22-2011 08:17 AM
Hi,
Connect with console cable and enter CLI and do these commands:
-enable "followed by enable password if configured"
-show run
Post the output of this command as attached file.
Regards.
Alain.
03-22-2011 10:27 AM
Here you are the running config (see adj.) , and I copied discover fail messagge too. Thanks
03-22-2011 01:14 PM
Hi,
Can you try this command in CLI gobal config: no ip http access-class 23
Let us know and by the way you must login as user with privilege 15
Regards.
Alain
03-23-2011 11:31 AM
I tried but the problem follows.
At present I am in contact to Chaitra Gopinath (support CCP) who is helping to me
I have tried other commands but without sucessfull at this moment.
Thanks a lot
05-26-2011 02:47 AM
Hi Ruben,
I guess you are able to use CCP 2.5 with out any problem.
Thanks
Chaita
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide