10-30-2014 09:41 AM - edited 03-05-2019 12:04 AM
Hi
I have a problem with my new HWIC-1ADSL card and Router 2901 with ios "c2900-universalk9-mz.SPA.152-4.M5.bin", I tried to update ADSL card firmware with variety version but unfortunately It didn't work.
Does anyone have any idea how can I fix this problem?
Here's some info from my hardware:
Output of show int atm 0/0/0
ATM0/0/0 is down, line protocol is down
Hardware is HWIC-DSLSAR (with Alcatel ADSL Module), address is 6412.2530.e4c8 (bia 6412.2530.e4c8)
MTU 4470 bytes, sub MTU 4470, BW 2048 Kbit/sec, DLY 250 usec,
reliability 0/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Keepalive not supported
Encapsulation(s): AAL5
23 maximum active VCs, 256 VCs per VP, 0 current VCCs
VC Auto Creation Disabled.
VC idle disconnect time: 300 seconds
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: Per VC Queueing
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
Output of show dsl int atm 0/0/0
ATM0/0/0
Alcatel 20190 chipset information
Line has not yet been activated.
Modem Status: Down (DMTDSL_DO_OPEN)
DSL Mode: Unknown
Interrupts: 318704 (0 spurious)
PHY Access Err: 0
Activations: 0
LED Status: OFF
LED On Time: 0
LED Off Time: 0
Init FW: init_AMR_4.0.018.bin
Operation FW: AMR-E-4.0.018.bin
FW Source: external
DSL: Training log buffer capability is not enabled
Thank you in advance.
10-30-2014 08:21 PM
ATM0/0/0 is down, line protocol is down
Layer 1 problem. You sure something is connected to the port?
10-30-2014 10:43 PM
Yeah, I've checked my line via a ADSL modem and the link came up correctly.
There isn't any error on the link, and ADSL line.
10-31-2014 12:00 AM
reliability 0/255, txload 1/255, rxload 1/255
Not sure. You may have a faulty HWIC-1ADSL then. This other thing is showing you've got a Layer 1 problem.
So if you plug the line straight to your cable modem and it's good but it doesn't work here then it could be a hardware issue.
Post your config.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide