cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2808
Views
0
Helpful
1
Replies

Problems connecting Cisco 887 VA router to Vodafone broadband

james
Level 1
Level 1

Hi All,

I am trying to connect a 887 VA router to Vodafone broadband in Ireland office. I am ripping my hair out now trying to get a connection to the internet. I have the following config - can anyone see where I have gone wrong?

I am connecting to ADSL+ service using built in modem in router over standard phone line. I have a static assigned external IP with the broadband service.

Thankyou so much to anyone who can help -  below the config is a screen shot of the show controller vdsl 0 command and the debug info that it gives.

!
!
no ip domain lookup
ip domain name globalhomeireland.com
ip host view Primary www.globalhomegroup.com 93.107.38.138
ip name-server 8.8.8.8
ip cef
no ipv6 cef
!
!
multilink bundle-name authenticated
vpdn enable
!
vpdn-group 1
!
vpdn-group GLOBAL-VPN
! Default PPTP VPDN group
description Default PPTP VPDN group
accept-dialin
  protocol pptp
  virtual-template 1
!
license udi pid CISCO887VA-SEC-K9 sn FCZ172390QW
!
!
!
!
!
!
!
controller VDSL 0
!
no ip ftp passive
!
!
!
!
!
!
!
!
!
interface Loopback0
no ip address
!
interface Ethernet0
description $WAN_OUTSIDE$
no ip address
no ip route-cache
shutdown
pppoe enable
pppoe-client dial-pool-number 1
!
interface ATM0
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
ip flow ingress
no atm ilmi-keepalive
!
interface ATM0.1 point-to-point
ip address 93.107.38.138 255.255.255.0
pvc 8/35
  protocol ip 89.19.65.189 broadcast
!
!
interface FastEthernet0
no ip address
no cdp enable
!
interface FastEthernet1
no ip address
no cdp enable
!
interface FastEthernet2
no ip address
no cdp enable
!
interface FastEthernet3
no ip address
no cdp enable
!
interface Vlan1
description Internal GH LAN
ip address 192.168.10.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
!
interface Dialer0
description ADSL WAN Dialer
ip address negotiated
no ip redirects
no ip unreachables
no ip proxy-arp
ip mtu 1492
ip flow ingress
ip dns view-group Primary
ip nat outside
ip virtual-reassembly in
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication chap pap callin
ppp chap hostname xxxxxxxx@vodafone.com
ppp chap password 0 broadband
ppp pap sent-username xxxxxxxxx@vodafone.com password 0 broadband
no cdp enable
!
ip forward-protocol nd
ip http server
ip http authentication local
ip http secure-server
!
!
ip dns view Primary
ip nat inside source list 101 interface Dialer0 overload
ip nat inside source static tcp 192.168.10.1 3389 interface Dialer0 3389
ip route 0.0.0.0 0.0.0.0 Dialer0
!
no service-routing capabilities-manager
dialer-list 1 protocol ip permit
no cdp run
!
access-list 101 permit ip 192.168.0.0 0.0.255.255 any
access-list 101 permit ip 192.168.10.0 0.0.0.255 any
access-list 101 permit ip any any
access-list 101 permit icmp any any
access-list 101 permit udp any any
--More--
!
control-plane
!
!
!
line con 0
exec-timeout 5 30
password ???????
login
no modem enable
line aux 0
line vty 0 4
password ????????
login
transport input all
!
!
end

Debug showing PPPoe stuff

Controller VDSL 0 is UP

Daemon Status:           Up

                        XTU-R (DS)              XTU-C (US)
Chip Vendor ID:         'BDCM'                   'IFTN'
Chip Vendor Specific:   0x0000                   0x8279
Chip Vendor Country:    0xB500                   0xB500
Modem Vendor ID:        'CSCO'                   '    '
Modem Vendor Specific:  0x4602                   0x0000
Modem Vendor Country:   0xB500                   0x0000
Serial Number Near:    FCZ172390QW 887VA-S 15.3(1)T
Serial Number Far:
Modem Version Near:    15.3(1)T
Modem Version Far:     0x8279

Modem Status:            TC Sync (Showtime!)
DSL Config Mode:         AUTO
Trained Mode:            G.992.5 (ADSL2+) Annex A
TC Mode:                 ATM
Selftest Result:         0x00
DELT configuration:      disabled
DELT state:              not running
Trellis:                 ON                       ON
SRA:                     disabled                        disabled
--More--
*Jul 31 13:46:56.066: (Ethernet0): Null atm_db
*Jul 31 13:46:56.066: (atm_vc_is_bridged_dot1q)ATM: VC with handle 0x0 not found

*Jul 31 13:46:56.066: (atm_vc_is_bridged_dot1q)ATM: VC with handle 0x0 not found
SRA count:              0                       0
Bit swap:                enabled                         enabled
Bit swap count:         1                       0
Line Attenuation:        25.0 dB                 11.1 dB
Signal Attenuation:      25.6 dB                 11.2 dB
Noise Margin:             6.2 dB                 11.4 dB
Attainable Rate:        22440 kbits/s            1192 kbits/s
Actual Power:             0.0 dBm                12.6 dBm
Total FECC:             440                      0
Total ES:               32                       0
Total SES:              31                       0
Total LOSS:             3                        0
Total UAS:              14825                    14825
Total LPRS:             0                        0
Total LOFS:             25                       0
Total LOLS:             0                        0

Full inits:             4
Failed full inits:      4
Short inits:            4
Failed short inits:     0

Firmware        Source          File Name (version)
--------        ------          -------------------
VDSL            embedded        VDSL_LINUX_DEV_01212008 (1)

Modem FW  Version:      120306_1254-4.02L.03.A2pv6C035j.d23j
Modem PHY Version:      A2pv6C035j.d23j
Vendor Version:         Ap6v35j.23j 68


                  DS Channel1     DS Channel0   US Channel1       US Channel0
Speed (kbps):             0            18428             0              1020
SRA Previous Speed:       0                0             0                 0
Previous Speed:           0            18428             0              1020
Total Cells:              0          2081256             0             91777
User Cells:               0              450             0                 0
Reed-Solomon EC:          0                0             0                 0
CRC Errors:               0             1379             0                 0
Header Errors:            0                0             0                 0
Interleave (ms):       0.00             7.89          0.00              1.13
Actual INP:            0.00             2.02          0.00              0.00

Training Log :  Stopped
Training Log :  Stopped

1 Reply 1

James Neilson
Level 1
Level 1

Your static IP address should be on the dialer interface not the atm0.1 interface

The atm config should be similar to:

interface atm0
no ip address
bundle-enable
dsl operating-mode auto
!
interface atm0.1 point-to-point
no ip address
no ip directed-broadcast
no atm ilmi-keepalive
pvc 8/35
  pppoe-client dial-pool-number 1

Add the below to the dialer:

interface Dialer0

ip address 93.107.38.138 255.255.255.0