Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi,please check this diagram, ospf running in frame relay cloud (hub and spoke)  everything work fine, but after adding Router 4 (Eigrp) the other routers can't reach to router4 but it can ping Router1 eigrp interface(75.75.75.1).Router1 configBuildi...

hi,I am getting error message in my cisco 1841.I am using E1 card and next end is terminated to modem(e1 to V.35) and its  connected to router serial port.i have configured at both end but status in not comming up in E1 interface.Also geeting this me...

ajf303 by Level 1
  • 1095 Views
  • 4 replies
  • 0 Helpful votes

                  Dear Expert,I have two ISP with few MPLS connectivies. i am planning to establish EIGRP with loadbalancing. any configuration sample..?attached diagram for ref.And, what is route-map..? is it possible to apply over EIGRP interfacess...

ajf303 by Level 1
  • 2151 Views
  • 3 replies
  • 0 Helpful votes

I am trying to set up an ASR with 10Gb connectivity. I noticed a new card that does not appear to show up in any data sheets. This card is considerably less expensive than the other SPAs and I am wondedring what the differentiators are for this card....

Hello,I've configured a few small hub and soke networks before where you only have 1 hub and 3-4 spokes, but today I saw a hub and spoke diagram that had 2 hubs!  I'm not seen this before and have wondered how on earth you would configure the hubs an...

There around 70 remote sites and head end is of 200 mbps MPLS WAN link..Platform: 7206VXR, IOS: 12.4(15)T7The QOS configuration at present is attached..At the head end, we would like to shape based on remote sites bandwidth. Having said that, how man...

                   Dear All,Kindly help analyse the attached proposed network topology of my company (and the branches) and advise me appropriately.I want to know if the design could work fine or if there are better way to achieve using different des...

Nabaruma by Level 1
  • 5074 Views
  • 15 replies
  • 0 Helpful votes

can somebody expalin me why 255 taken as mask instead of 128 in the first example.and why 192 has been taken as mask in 2nd example. i got this confusion while doing subnetting of class B network. please help me.1).Practice Example #6B: 255.255.255.1...

I have a brand new C1921 with EHWIC-4G-LTE-G using Vodafone to build an internet connection.First I did the setup like shown in the config guides and got the internet connection, but it was unstable. Then I found some issues with the old LTE-card fir...

hkitsch by Level 1
  • 1535 Views
  • 1 replies
  • 0 Helpful votes

Dear All,We've have a client who had a ordered 2 units of 2901 router to have site to site connectivity. User has bought a leased line of 256kbps from service provider in between two sites, but the issue is the service provider has layed a rj11 cable...

Hi,I have had a replacement router sent out to me due to a fault with the AP.It had a really old firmware on the AP, which I have updated. Using CCP, I have a wireless network running which is more than I had with the old router.The issue I have is t...

Review Cisco Networking for a $25 gift card