cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
362
Views
0
Helpful
3
Replies

QoS configuration

levisbasto
Level 1
Level 1

Hi,

 

On a router cisco 1941 I want to configure QoS but I don´t know if I have to configure the polyce in the fisical interface or in the subinterfaces whit the IP address.

3 Replies 3

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Do you know what you what your QoS policy to achieve?

What IOS is on the 1941?

What's a "fisical" interface?

Jerry Paul
Level 1
Level 1

Hi,

 

You can use QoS in both interfaces.

Luke Smith
Level 1
Level 1

I'm assuming you're talking about the policy and the physical interface or logical interface, which I have my employees configure it on the physical interface and it works fine.

Review Cisco Networking for a $25 gift card