Routing

Hi all,I have a Cisco 3900 series Router with the following characteristics:Cisco IOS Software, C3900 Software (C3900-UNIVERSALK9-M), Version 15.0(1)M2, RELEASE SOFTWARE (fc2) I have two VDLS connections, my ISP cant really offer good speeds, so we h...

 Hi, I am having cisco 7606-S router with  sup engine RSP720-3C-10GE  and loaded IOS is c7600rsp72043-advipservicesk9-mz.153-1.S2.bin.i am facing problem that router gets reboots automatically and both sub gos to Rommon mode, then i have to boot it w...

With the advent of Smart-Serial and Internal DSUs, I'm now left with hundreds of the fat winchester DB-60 style serial cables.Does anybody know of environmentally friendly businesses that can dispose of or recycle these?Thanks In Advance!

I have a Cisco 2501 (Router A) subscribe to 2 different services provider for about 3 years. Serial 1 connect to ISP XSerial 0 connect to ISP YYesterday, I connect my (2501 Router B) to a new office and remain subscribe to same services provider.Howe...

Dear Sirs!What I can change IP address????I try....SCE2000(config if)#>ip address 192.168.55.221 255.255.255.0and get!++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ NOTE: SCE reload is required for the new IP/subnet to tak...

Hi to all,I have a problem with a Cisco 877VA and a HP FF5700 switch.In the C887VA, I have configured three vlan: 200 as a native vlan, 202 and 203 tagged in the port. When I configure, in the switch, the port as a hybrid link type port (with this mo...

What would be some good debug commands to run on a Cisco 881 SOHO router that is connecting via DMVPN back to a data center but experiencing VPN disconnections from time to time?

hi, can i use Cisco BiDi SFP or Gbic fiber module using single fiber core..i need 500 Mbps bandwidth up to 35 km distance.

The Cisco 2901 router has the securityK9 perminate license activated.but the router is still getting error message %CERM-4-RX_BW_limitWhat would cause this error and what is needed to correct it.

I was able to configure the IP Address but how about the Default GatewaY? I did ip address 200.2.14.2 subnet 255.255.255.248What's the command for default gateway let's say the gateway is 200.2.14.1?

Hi everyone,I'm trying to configure the C867VAE as a Hub VPN router and use VPN client as Shrew soft or Cisco QuickVPN on PC to mount IPSec tunnel between.At present, I've Ezvpn remote sites working with this Hub site. So I add a profile for VPN clie...

Since the home router is the DNS server, the Asa has no internal DNS which is probably the cause of no internet. Is there any way around this?