Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm new to the Nexus line and I'm seeing that it does not fall in line with any other Cisco IOS that I've used before. What I'm trying to do is a very basic setup. I'm using this switch as basically a Layer 2 switch but with remote management via the...
I have an interesting issue. I sporadically have a customer who reports no internet. When I look at their NAT translations in our ASR1002 it shows 1 or 2 TCP translations and the rest are UDP. The moment they start working again it shows many more NA...
I'm in the process of converting my cgNAT solution from an ASA5555 to an ASR1002. I can do the basic "ip nat inside list NAT interface interface overload" and it works fine but I'd like to know if its possible to keep the solution I had with the ASA....
I am partnering with another service provider and they use a single VLAN for their management and we are about to turn a second connection. To get the VLAN's they need, I've been doing an ethernet pseudowire via MPLS to the respective switch within m...
I'm trying to upgrade the firmware of my Cisco ASA 5515 from 9.1.1 to 9.8.1. I know I need to go to 9.1.2 before I can go to 9.8.1, but everytime I try to copy 9.1.2 to flash I get the error "No Cfg structure found in downloaded image file" I'm not e...
I need the ability to manage it though, All ports are in a shutdown state, so as I turn up new interfaces I'm going to need a way to get into the device remotely as I manage the switch not the equipment that plugs into it. I tried to do "interface vl...
I had tried the timeout of 300 and it caused more damage then good. I will look into the rotary command, however the pools right now are single IP addresses so I don't think rotary would cause any difference right now.
This is the best part of it all ... What provoked the problem? Unknown, no changes were made.What resolved the problem? Unknown, no changes were made. As for logging level, it is set to debug and all I see are TCP session creation/deletion messages a...
Yes this could work, if I had layer 3 capabilities but I am only a layer 2 provider in this instance. I don't have CE access, I'm just providing the "last mile" to the end customer and their purchasing provider. I actually have that working elsewher...
Thank you for your response. This has been said multiple times already. I am trying to do this, I am getting the error when I try to put 9.1.2 on my ASA which is currently on 9.1.1.
