Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
3759
Views
0
Helpful
1
Replies

QoS for 6800

bapatsubodh
Level 1
Level 1

‎09-26-2015 04:41 AM - edited ‎03-05-2019 02:23 AM

Hi,

On Cisco switch-series 6800, what is the default policy for QsS on incoming packets on L3 links. 

Does the "switch" trusts the existing DSCP marking or we need to configure "mls trust" separately on each L3 interface to trust DSCP.

Any link on cisco.com?

Please share the experience.

Thanks in advance..

Subodh

Labels:
0 Helpful
1 Reply 1

paul driver
VIP
VIP

‎09-26-2015 01:40 PM

Hello

Usually default policy when enablling MLS qos is to NOT to trust any qos markings.however saying that I am not aware of 6800's.qos

 

Here is the 6800 cco docs for qos
 

6800 config guides

6800 Qos

res
Paul
 


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card