Routing

hi, i need to know all things about WAN connection can i use ADSL? how many distance it provide? i need WAN technology that support high distance and low price thanks

hi all, i would like to know if 2911 (or any of its IOS) supports the serial interface command ignore cts. the 3925 has it but not the 2911. was wondering if it's a platform or IOS limitation. could someone please advise if this is supported on 2911?...

hi all, i'm trying to debug some routing on an IPsec router. GRE over IPsec VPN works and establish but pings seem to fail and not sure if upstream client DSL router is blocking it. i already include a deny ACE for the VPN private IP for the NAT ACL ...

Hello, I have a Cisco 877 and i want to register on it two ADSL lines. One PSTN and one ISDN. I have successfully registered the PSTN line with this config: -=-=-=-=-=-=-=-=-=-=-= interface ATM0 no ip address no atm ilmi-keepalive pvc 8/35 pppoe-cl...

Welcome to this Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and any ask questions about how to configure and troubleshoot and design netowrk using  Border Gateway Protocol with Cisco expert Vinit Jain. Ask que...

Hi all, As shown in network diagram, Just wondering if it is mandatory to run iBGP in Switch1 and Switch2.  I guess it should be okay if it  we run  iBGP in both boarder routers and use default-information originate in BR1 and BR2 with metric. Pls...

We have a hub and spoke topology and we have two spokes. When mGRE is configured, the traffic doesnt pass through the hub. Assume that each spoke has one connection to the hub, how does the traffic gets through when there is no physical connection be...

Hello! On a Cisco 2911 I have 2 public ip addresses allocated by the ISP on port Ge0/0: aaa.bbb.ccc.85/24 and aaa.bbb.ccc.87/24 (both use the same gateway) Private lan is vlan based (I also have voip configured) on Ge0/1 Recently the ISP allocated ...

Hi I believe that cisco 887VA 15.154-3.M4 has a bug related to throttle packets.  Below the scenario: interface Vlan1 description +--IP_MGMT+TRAFFIC--+ ip address 10.0.0.1 255.255.255.0 ip nbar protocol-discovery ip nat inside ip virtual-reassembly i...

We're running OSPF point-to-multipoint on two different asynchronous CES clouds so that we can use neighbor statements to define the bandwidth of slower neighbors.  Up until now it has been working great, but now I'm experiencing an odd issue with on...

Hello I try to configure my Router 887VA to automaticly reload if an IP-Adress is not reachable. I tried the following configuration: --------------------------------------------ROUTER#conf t ROUTER(config)#ip sla 1 ROUTER(config-ip-sla)#icmp-echo 10...