01-10-2020 12:40 PM
Hi All,
I have a scenario where i need a little help. it's like a Router on a stick config but with a firewall in the middle. I have a cisco switch, a sophos firewall and the rv340 router. i have setup 2 vlans on the switch and same vlans on the rv340 router. On the firewall however, i have configured it in the bridge mode (lan and wan ports are configured as bridge and they are bridged to passthrough the traffic) and the gateway for this bridge interface is the vlan1 subinterface on the router (192.168.0.1). If i ping vlan 1 interface from the switch (192.168.0.1), it is successful but when i ping the vlan 2 router interface (192.168.2.1) from the switch, it is not working. Because the firewall bridge interface has it's gateway set as 192.168.0.1 (vlan1), when i ping router vlan2 interface, will the router automatically push the traffic onto vlan 2 interface and let it reply the ping?
Solved! Go to Solution.
01-14-2020 09:39 AM
01-10-2020 12:57 PM
Hello,
--> but when i ping the vlan 2 router interface (192.168.2.1) from the switch
Is the Vlan 2 interface a subinterface on the same interface as the Vlan 1 subinterface ?
01-11-2020 08:25 AM
01-10-2020 03:42 PM
Hello
Doesn't make sense at this time why you are bridging - it sounds like you have the switch between the rtr and fw is that correct?
Can you post the topology of this network please
01-11-2020 08:30 AM
01-14-2020 09:39 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide