Recently, I am migrating from 2900 to 8200. When trying to copy rate-limit configuration, the command is rejected.
on 2900:
interface GigabitEthernet0/2
description AIRTEL_MPLS_20Mb
ip address x.x.x.x
ip flow ingress
ip flow egress
rate-limit input access-group 117 16384000 3072000 6144000 conform-action transmit exceed-action drop
rate-limit input access-group 116 4096000 768000 1536000 conform-action transmit exceed-action drop
rate-limit input access-group 114 4096000 768000 1536000 conform-action transmit exceed-action drop
rate-limit input access-group 113 1024000 384000 768000 conform-action transmit exceed-action drop
rate-limit input access-group 109 8192000 1536000 3072000 conform-action transmit exceed-action drop
rate-limit input access-group 108 8192000 1536000 3072000 conform-action transmit exceed-action drop
rate-limit input access-group 112 8192000 1536000 3072000 conform-action transmit exceed-action drop
rate-limit input access-group 107 8192000 1536000 3072000 conform-action transmit exceed-action drop
rate-limit output access-group 117 16384000 3072000 6144000 conform-action transmit exceed-action drop
rate-limit output access-group 116 4096000 768000 1536000 conform-action transmit exceed-action drop
rate-limit output access-group 114 4096000 768000 1536000 conform-action transmit exceed-action drop
rate-limit output access-group 113 1024000 384000 768000 conform-action transmit exceed-action drop
rate-limit output access-group 109 8192000 1536000 3072000 conform-action transmit exceed-action drop
rate-limit output access-group 108 8192000 1536000 3072000 conform-action transmit exceed-action drop
rate-limit output access-group 112 8192000 1536000 3072000 conform-action transmit exceed-action drop
rate-limit output access-group 107 8192000 1536000 3072000 conform-action transmit exceed-action drop
load-interval 30
duplex full
speed 100
end
---------------------------
On 8200L
New-Router(config-if)#rate-limit
% Unrecognized command
----------------------------
New-Router(config-if)#r?
% Unrecognized command
I searched on cisco, but couldn't find an answer.
