in a MPLS scenario i saw that in last line of configuration requirement it mentioned :
for any simplify future changes,your configuration must not limited to any prefixes.
the total requirement about MPLS backbone and some others branches which already connected through it.
for that requirement not limited to prefixes i think that it means i have to play with RD and Route-Target values in order to specify which prefixes should be accepted (received by PE from CE) which one NOT !
before this line just there was some demand that said which branches have to received which Branch's Prefixes
I am trying to get the answer from the document below:http://www.cisco.com/c/en/us/products/collateral/switches/nexus-3000-series-switches/white_paper_c11-726674.pdf But, when I click on it, it didn't give me the document itself. Can someb...
(Pdf copy at the bottom)
Segmentation within SD-Access is enabled through the combined use of both Virtual Networks (VN), which are analogous to VRFs, and Cisco Scalable Group Tags (SGTs). VNs, like VRFs, provide comp...
The 2020 IT Blog Awards, hosted by Cisco, is now open for submissions through October 16. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https://www.cisco...
Hello,We have a pair of N3K-3064PQ-10GX and one of them acting as backup and we want to migrate from VyOS to it, we want to add 500x interface vlan and each interface vlan has its own ip/prefixes (for example /30 /29 ...) and we ahve 6-8x BGP session with...
We live in an age that is both thrilling and evolving substantially. A new trend/technology is always on rise even before the preceding has been used to its fullest potential. Although the concepts of digital transformation may seem over discussed, ...