Replace two routers and 1 switch with 1 catalyst 2960

[OraWiz]

I currently have two routers and one switch with 2 vlans.  Is it possible to configure a catalyst 2960 to replace all three? 

Switch configuration:

vlan 1: Ports 1-15

vlan 2: Ports 16-20

vlan 1 - IP range is 10.10.10.0 255.255.255.0

vlan 2 - IP range is 69.25.25.0 255.255.255.0

Router 1 IP addresses are 10.10.10.1 and 10.10.9.2

Router 2 IP addresses are 69.25.25.1 and 69.30.20.78

How would I configure the 2960 to be able to route traffic from 10.10.10.0 to 10.10.9.1

and route traffic from 69.25.25.0 to 69.30.20.73

[balaji.bandi]

yes it is possible, but what is the role of 2 routers, is this high availability ?

if you replace with 1 switch you will not get that resilience.

So explain more about exiting setup in detailed.

[Joseph W. Doherty]

I believe that depends on the model of 2960 and its IOS version. Some 2960 models, I believe, only support L2 while some 2960 models (I think starting with the 2960S series) support some very limited routing.