Solved: Replacement for 3825 full bgp table

achim · ‎10-16-2019

Hi community,
we are looking for a replacement for our 2 Cisco 3825 with 768mb ram.
We have bgp multihoming with full bgp table, 2 ISPs, 2 times 100mbit/s.
The 3825s are slowly getting problems with the load.
Is the Cisco C881-K9 a good choice?
Or is there a recommendation for a suitable hardware?

Thank you in advance.

Best regards

Achim

paul driver · ‎10-16-2019

Hello

Have look here - cisco 3825 replacement
In the interim - to save rtr resource etc and especially when your receiving a full bgp internet table, If you have soft-inbound reconfiguration enabled and if your router and if your bgp neighbors support the capability then you could utilize route refresh instead this should save you quite a lot of rtr resource whilst you decide what rtr upgrade you go for?

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

View solution in original post

paul driver · ‎10-16-2019

Hello

Have look here - cisco 3825 replacement
In the interim - to save rtr resource etc and especially when your receiving a full bgp internet table, If you have soft-inbound reconfiguration enabled and if your router and if your bgp neighbors support the capability then you could utilize route refresh instead this should save you quite a lot of rtr resource whilst you decide what rtr upgrade you go for?

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul