01-31-2007 08:36 AM - edited 03-03-2019 03:34 PM
How do I reset the configuration of a Catalyst 2900 without going through the command prompt?
Thanks,
01-31-2007 04:36 PM
Hello,
If you have an IP address on the 2900 Switch you can use your browser and point it to the URL address http://Switch_IP_address
THere you can reset the configuration.
However, if the switch does not have IP address of the web installed and enabled you have to use the console.
Once in the console issue the below commands
enable
"enter enable password"
wr er
reload
Let me know if this helps,
Appreciate your rating,
Regards,
01-31-2007 08:22 PM
Hello,
Is special configuration required for http
02-01-2007 02:25 AM
No way to. I can only guess that the reason that you would ask that question is because you do not know the password.
You can find password recovery procedures here:
http://www.cisco.com/warp/public/474/
Cheers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide