03-13-2018 03:01 AM - edited 03-05-2019 10:05 AM
Hello Experts,
I want to segregate RTP and OTHER traffic.
RTP must go Via MPLS link (Static : MPLS provider IP: 172.24.56.2)
OTHER should traverse via ISP1 (INTERNET).
and in breakdown of MPLS, ISP1 should take all traffic.
in breakdown of ISP1, MPLS should take all.
Here is my config:
INSIDE Interface is connecte don vlan 6:
int gig0/1
desc *** Internet ISP1 ***
IP address xxx.xxx.xxx.xxx/29
!
int gig0/2
des *** To MPLS ***
ip address 172.24.56.1 255.255.255.248
!
int vlan 6
desc *** LAN ***
ip address 10.56.xx.xx/24
ip policy route-map VIDEO
!
route-map VIDEO permit 5
description *** only Video Traffic ***
match ip address VIDEO
set ip next-hop verify-availability 172.24.56.2 track 56
!
route-map SAP_VIDEO permit 6
!
ip access-list extended VIDEO
remark *** RTP ****
permit udp any any range 16384 32767
permit udp any range 16384 32767 any
deny ip any any
!
int tu 556.
tunnel source xxx.xxx.xxx.xxx
skip
.
GRE Tunnel to HQ......
!
router eig 1
network 10.56.0.0 0.0.255.255
skip
......
so there are two routes ..one via PBR (only for VIdeo) and other is via GRE tunnel.
is it correct ?
Thanks in advance
03-13-2018 03:35 PM - edited 03-13-2018 03:40 PM
When you using PBR, you have to select specific Source address to route to specific next-hop. Did you specify which source subnets you need to go via MPLS and ISP1 (as per ACL its Allowed all Source) ?
Did you want to apply conditional static routes if MPLS fails to switch over to tunnel (checking IP SLA or Tracking)
03-13-2018 11:07 PM
Hi Ranil,
My aim is to pass VIDEO traffic via MPLS (If its avilable) and rest via Internet VPN. If MPLS goes down then all traffic via INternet and vice versa,
Thanks
03-13-2018 11:49 PM
is anyone confirm, if this config will work or not ??
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide