02-25-2011 06:01 AM - edited 03-04-2019 11:34 AM
Hi All
Just to get confirmation on an issue that I have struck, if you need to perform updates to a route-map that is in production for say static/connected route redistibution in BGP, and you want to remove an enty from the route map, say a prefix-list, do you need to remove the whole route map statement from the BGP redistribution statement, do the update and put it back ...... or do you just do the updates to the route-map referred to and all is well?
Thanks
Dave
Solved! Go to Solution.
02-25-2011 06:26 AM
It is normally sufficient to modify the prefix list and perform a soft reconfiguration in or out.
For extensive modifications, I would create a new prefix list and corresponding route map.
Then replace the old route map for the new one in the neighbor commands.
This is a quicker (and safer) solution in case you need to fall back to the previous config.
regards,
Leo
02-25-2011 06:26 AM
It is normally sufficient to modify the prefix list and perform a soft reconfiguration in or out.
For extensive modifications, I would create a new prefix list and corresponding route map.
Then replace the old route map for the new one in the neighbor commands.
This is a quicker (and safer) solution in case you need to fall back to the previous config.
regards,
Leo
02-25-2011 09:22 AM
You can just do an update in the route map.
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide