12-03-2019 06:49 AM
I need to redistribute some OSPF routes into EIGRP. pretty simple. But I built a filter (for testing basically) to limit what routes get put in. Like so:
ip access-list test-distrib-ospf-to-eigrp
10 permit ip 10.120.32.0/24 any
route-map ospf-to-eigrp permit 10
match ip address test-distrib-ospf-to-eigrp
when I did the redistribution from ospf to eigp:
router eigrp 1
router-id 10.4.199.2
default-metric 1000 30 255 1 1500
redistribute ospf 1 route-map ospf-to-eigrp
it ignored my route map and redistributed everything from ospf into eigrp.
the spelling of the names of the ACL and the route map are matching...so what did I do wrong?
I read one article where it stated that the route map doesn't pay attention to the prefix length but...I've got PBR using specific (/32) addresses to reroute specific traffic, and that works just fine. So what did I do wrong here?
Solved! Go to Solution.
12-03-2019 07:56 AM
actually I may have just found my problem...ip prefix list would be a better choice than an ACL like we would have used on a router or even 3850...testng now...
12-03-2019 07:56 AM
actually I may have just found my problem...ip prefix list would be a better choice than an ACL like we would have used on a router or even 3850...testng now...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide