Hello
I have a question referent at Router 2811 i can't load the ios since flash: when this start or reload, this send a message referent to not recognize the flash: and tha no contein the valid FS, this make when i want to charge the image since flash:, usb or tftpdnld -r (whit this the router not reload when finish the load the image) and xmodem, i don't know what is the problem...
I hope that somebody can help me thank you
System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2004 by cisco Systems, Inc.
Initializing memory for ECC
.
c2811 processor with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
Readonly ROMMON initialized
device does not contain a valid FS
loadprog: error - on file open
boot: cannot load "flash:c2800nm-adventerprisek9-mz.124-15.T9.bin"
c2811 processor with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
Readonly ROMMON initialized
device does not contain a valid FS
boot: cannot open "flash:"
boot: cannot determine first executable file name on device "flash:"
c2811 processor with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
Readonly ROMMON initialized
device does not contain a valid FS
boot: cannot open "flash:"
boot: cannot determine first executable file name on device "flash:"
c2811 processor with 262144 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC enabled
Readonly ROMMON initialized
rommon 1 >
rommon 1 > dir flash:
device does not contain a valid FS
dir: cannot open device "flash:"
rommon 2 > dev
Devices in device table:
id name
flash: compact flash
bootflash: boot flash
eprom: eprom
rommon 3 > ?
alias set and display aliases command
boot boot up an external process
break set/show/clear the breakpoint
confreg configuration register utility
cont continue executing a downloaded image
context display the context of a loaded image
cookie display contents of motherboard cookie PROM in hex
dev list the device table
dir list files in file system
dis disassemble instruction stream
dnld serial download a program module
frame print out a selected stack frame
help monitor builtin command help
history monitor command history
iomemset set IO memory percent
meminfo main memory information
repeat repeat a monitor command
reset system reset
rommon-pref Select ROMMON
set display the monitor variables
showmon display currently selected ROM monitor
stack produce a stack trace
sync write monitor environment to NVRAM
sysret print out info from last system return
tftpdnld tftp image download
unalias unset an alias
unset unset a monitor variable
xmodem x/ymodem image download
rommon 4 > cont
cont: can not continue, no system kernel context
rommon 5 > context
context: kernel context is not valid
rommon 6 > boot flash flash:c2800nm-ipbase-mz.124-3i.bin
device does not contain a valid FS
boot: cannot open "flash:"
an alternate boot helper program is not specified
(monitor variable "BOOTLDR" is not set)
and unable to determine first file in bootflash
loadprog: error - on file open
boot: cannot load "flash flash:c2800nm-ipbase-mz.124-3i.bin"
rommon 7 >
