Routing

Hi I have a 857w and a 857 router but there doesnt seem to be any HSRP and VLAn support on either router. I have ADVsevcurity on the routersdo Ineed a different IOS or is it just not supported.regardsPaul

Hi we have two servers which are hosted at two different location and we want to load balance the traffic for these two server in Active/ standby mode details are as below 1)    Server-A IP address is 10.10.2.50/24 and Server-B would be 20.20.20.50/2...

Hi everybody,we have a problem with a Cisco 1841 router while booting. The router is loading the image from the CF card but gets stucked at this point:This product contains cryptographic features and is subject to UnitedStates and local country laws ...

Hi,  I have a live scenario in which there are 2 routers R1 and R2 -each has a WAN link to ISP1 and ISP2 respectively.I am getting full routing table from both ISP's thru EBGP and I m advertising my IP block to both ISP's.Also I have configured HSRP ...

I have an issue with connecting my OPTEMAN 100mb handoff to the 3750 ME ES ports.Because the ES ports will only accept gig connections, I am unable to use the ES ports.Is there a work-around? It's too costly to have the OPTEMAN changed over to a GIG ...

Hi, Our remote location is connected with HO with two ISP. Primary path is ISP1 & Backup Path is ISP2.Now we have configured Policy Base Routing & My Objective was below. 1.       Remote location will access 172.26.4.232 & 172.26.7.45 server via ISP2...

hiPlease find the attachedCan any one please tell me which is the bootdisk: or sup-bootdisk: in RSP-720-3C-GE ????? when the RSP card boots for the first time.Because you see in the attached picture there are two 512 MB memories in two different loca...

I have 2 Cisco 800's connected to each other with a VPNOne  thing that puzzles me - although I can ping and tracert between devices  on either side of the VPN I get a strange response from the remote  router when trying TraceRt to a remote server.eg:...

I have configured NAT load balancing, and it is not working. Below is  my configurationRTR#sh runBuilding configuration...Current configuration : 1722 bytes!version 12.4service timestamps debug datetime msecservice timestamps log datetime msecno serv...

Hi ,I have a problem, i have configured hsrp for P2P link which is on FE interface. for testing when i shut the primary link, the hsrp priority descreases, but the traffic does not go through secondary link. what could be the issue?i am attaching the...

Hi everyone,I have some questions about CBWFQ/LLQ :As explain in many cisco press book, CBWFQ determine preference between classes on  weight (derived from bandwidth command given to each class-map). So, packets in a class with a higher bandwidth wil...

Hi,3945 Router IOS Required  for support VoFR Feature please suggest me.

Hi All,I am new to the cisco IOS. As all know that there are two ways to configure the static route.asIP route 10.0.0.0 255.255.255.0 < next Hop IP Address >andIP route 10.0.0.0 255.255.255.0 <  Exit Interface >.Can anyone explain the diference betwe...