Router with 8 port E1 module in Single WIC

arjun.cisco · ‎01-08-2007

Dear All

Plz suggesst me the complied router for the below mentioned specs.,

high performance engine

modular design

compatibility with other end (ISP end)router

50 Kbps packet forwarding rate

WAN interface card with 8 E1 ports in single WIC

-sufficient flash memory(minimum 16 Mb)

-sufficient ram (minimum 256 MB)

-standard routing protool like RIP,OSPF,BGP

-monitoring of protocol statistics and performance of WAN bandwidth B40

-inrterface module support

LAN interface 10\100 base TX interfaces

WAN interface 8E1 line interface card

10\100 Mbps Ethernet interface card

-ACL packet filtering,NAT authentication audit DOS defense

-Policy based routing and low latency queuing

-WAN protocols

Multilink PPP

PPP

X.25

Frame Relay

-Comprssion payload and TCP/IP header

-congestion management

-Data Compression

-in activity time out

-security

-standard acces list and expanded access list B2B

Regards

Arjun

spremkumar · ‎01-08-2007

Hi Arjun

AFAIK you dont get them all in a single WIC instead you can look out for port adapters which can support your requirement..

You can check out for PA-MC-8TE1+ Port Adapter so that you can have all your E1s accomodated on a single card.

Below mentioned platforms brings in the support to have the same ..

Cisco 7200 Series Router with NPE-225, NPE-400, NPE-G1, NPE-G2, Cisco 7301, Cisco 7304, Cisco 7500 Routers

and Cisco 7600 Routers

Also refer the below link for more info about the port adapter card..

regds