Routing Between GETVPN and normal Tunnel interface

[SherifDiab]

Hello All,

I have a setup where all the Cisco routers are using GETVPN configuration.

Now I need to connect my SDWAN appliance to one of these Cisco routers but it only support normal IPsec tunneling on Tunnel interface.

Is there a way to include the Tunnel interface in routing with the GETVPN Tunnel-less set up?

the traffic flow should be as follows

LAN  -> SDWAN Edge -> IPsec tunnel -> Cisco router Tunnel interface -> GETVPN -> destination

Assum my LAN IP : 10.5.0.0/16

destination : 172.20.20.20

[Praveen Anand]

Hi Sherif, 

GETVPN/ GETVPN configuration is not  supported on IOS-XE SDWAN. however to answer your traffic flow questions, 

it would be a SDWAN ROUTER =========IPSEC Tunnel =======GETVPN ROUTER ======GETVPN MESH. 

you can route traffic with static routes. From Cedge perspective, it is just traffic being forwarded to the IPsec tunnel.