11-26-2018 06:13 AM - edited 11-26-2018 06:18 AM
Hello everybody
I am trying to setup some routing rules in my RV325 router.
I want to route all data from a subnet to a vlan which I created previously. But in the routing settings I can't choose my vlan in the interface row (see picture).
Am I missing something or can the RV325 not achieve this?
11-26-2018 06:37 AM
when you normally add a route, you would either use the next-hop IP or the outbound interface to reach your destination subnet
the following document might be helpful:
regards, mk
11-26-2018 06:42 AM
Hello,
under Port Management --> Vlan Membership, do you have Inter VLAN Routing enabled ?
11-26-2018 11:28 PM - edited 11-28-2018 02:27 AM
Yes.
So shouldn't I be able to chosoe vlan17 in 'Advanced Routing' as interface?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: