SDM is not showing SERIAL interfaces in itself
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-26-2007 05:33 AM - edited 03-03-2019 05:36 PM
Hi guys,
I am using SDM for checking the CPU utilization and Memory usage.
But when i check the INTERFACE STATUS in MONITOR mode, Only GigabitEthernet interface is showing with its bandwidth utilisation not any Serial Interface is displaying.
I want that Serial Interface connected to my Router with Multilink interface will display.
Any suggestion.
Sunny Rathore
- Labels:
-
Other Routing

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-26-2007 07:58 AM
Hello,
SDM has serious limitations in doing many things and quite possibly this is one of them (multilink).
For professional configuration and monitoring of cisco devices, please use CLI and traditional SNMP tools.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-26-2007 08:13 AM
Thanks for the info.
I am agree with you.
Sunny
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-14-2007 12:35 PM
Anyone find a fix for this? I have the same issue with SDM 2.4.1 on a 2800 series router.
SDM sees the serial interfaces in Montor Overview, and you can configure them in "Configure", but Interface Status won't let you monitor traffic. You'd think this would be a common [sense] need.
