se 0/1/0:0 protocol showing down even status up also

[mallesh.ch1]

MTMI(config-if)#do sh ip int brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0/0 10.194.58.8 YES NVRAM down down
GigabitEthernet0/0/1 unassigned YES NVRAM down down
GigabitEthernet0/0/2 unassigned YES NVRAM down down
Serial0/1/0:0 10.194.6.94 YES NVRAM down down
Serial0/1/1:0 unassigned YES unset down down
Serial0/2/0:0 unassigned YES unset down down
Serial0/2/1:0 unassigned YES unset down down
Serial1/0/0 10.194.12.5 YES NVRAM down down
Serial1/0/1 10.194.6.142 YES NVRAM down down
Serial1/0/2 10.194.3.85 YES NVRAM down down
Serial1/0/3 10.194.5.34 YES NVRAM down down
GigabitEthernet0 unassigned YES NVRAM administratively down down
Loopback0 10.194.254.58 YES NVRAM up up

[Flavio Miranda]

Hi

 All the interfaces is shown as down down. 

Which means, nothing connected to the interface. 

 I did not see any interface as UP down like suggested on  the title. 

 Can you confirm?

[mallesh.ch1]

please find it

[mallesh.ch1]

se 0/2/0:0 we changed same configuraion to this interface but same 

description SC-MTMI 2MB RCIL
bandwidth 2048
ip address 10.194.6.94 255.255.255.252

[Flavio Miranda]

I got it 

 You need to check both sides. 

 Please  share the command 

show run interface se 0/2/0:0

Please share from both devices.