Set Dialer interface to Simultaneously bring up both channels

[mks]

Hi,

I was wondering if it is possible to setup a dialer interface (BRI) to always bring up both channels to always allow 128k available instead of using the dialer load-threshold 1 and load-interval 30 commands.

If so could you please give me the commands for this, I would like to be able to run this on 2600 series routers and a 2811 routers.

My thanks in advance for your time and understanding.

Regards

Kal

[rais.ahmad]

How about setting the load threshold, to dial second channel, to 1?

Regards.

[m.lammerse]

Try:

'ppp multilink links minimum [mandatory]'

To specify the preferred minimum number of links in a Multilink PPP (MLP) bundle, use the ppp multilink links minimum command in interface configuration mode. To reset the default value, use the no form of this command.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/dial_r/dia_n1g.htm#wp1158197