01-15-2024 09:13 AM
Hi,
I have one 2821 router with this part of config;
redundancy interface Tunnel100 ip address 192.168.aa.bb 255.255.255.252 ip mtu 1400 ip authentication mode eigrp 2 md5 ip authentication key-chain eigrp 2 EIGRP ip tcp adjust-mss 1350 delay 5000 tunnel source Vlan48 tunnel mode ipsec ipv4 tunnel destination 10.xx.xx.xx tunnel vrf sp1 tunnel protection ipsec profile SP1_CRYPTO interface Tunnel200 description === to TP Var SDWAN via Vivacom === ip address 192.168.cc.dd 255.255.255.252 ip mtu 1400 ip authentication mode eigrp 2 md5 ip authentication key-chain eigrp 2 EIGRP ip tcp adjust-mss 1350 delay 10000 tunnel source FastEthernet0/1/0 tunnel mode ipsec ipv4 tunnel destination 83.xx.xx.xx tunnel vrf sp2 tunnel protection ipsec profile SP2_CRYPTO shared
Seems Tunnell100 is set as primary and Tunnell200 as reserve but i don't know how, I want to set Tunnell200 as primary and Tunnell100 as reserve. How to set higher priority for Tunnell200?
Solved! Go to Solution.
01-15-2024 09:14 AM
delay 10000
delay 5000
the answer is this, flapping the delay and check
MHM
01-15-2024 09:34 AM
Hello @boiadzhiew
Same answer as @MHM Cisco World
Adjust the delay on Tunnel200 to make it less preferable.
interface Tunnel100
delay 5000 # Adjust the delay value as needed !
interface Tunnel200
delay 10000 # Set a higher delay value than Tunnel100 !
01-15-2024 09:14 AM
delay 10000
delay 5000
the answer is this, flapping the delay and check
MHM
01-15-2024 09:34 AM
Hello @boiadzhiew
Same answer as @MHM Cisco World
Adjust the delay on Tunnel200 to make it less preferable.
interface Tunnel100
delay 5000 # Adjust the delay value as needed !
interface Tunnel200
delay 10000 # Set a higher delay value than Tunnel100 !
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide