06-15-2021 07:41 AM
I have two Cisco 4431-isr routers, running the same ios and rom-mon but the show commands are slightly different.
one router will accept the: 'show DMVPN' command and the other does not recognize the show DMVPN command.
What would cause this and how or can it be fixed?
Byron
06-15-2021 07:45 AM - edited 06-15-2021 07:46 AM
Hello @bymc ,
compare the file names of IOS images and also
show license
the difference should be there either in the IOS image or on the license level
There are other ways to check a DMVPN you can check NHRP activity and the IP routing table.
Hope to help
Giuseppe
06-15-2021 09:09 AM
BTW, what Giuseppe is pointing to is a difference in IOS feature sets between the two 4431s.
If using a "universal" type IOS, installed IOS file can be identical, but again, as Giuseppe is saying, enable features could differ based on licensing.
06-16-2021 04:16 AM
06-16-2021 02:14 PM
Hello @bymc ,
>>
The License was the same other than one had 'HSEC license' enabled and one did not.
The show DMVPN command worked on the router with HSEC enabled.
The license level is different and this explains what you see
Hope to help
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide