site2site VPN as backup for MPLS

[cgarringer]

I am designing a remote site that will have MPLS as primary and a site2site as backup, both connections on the same 2921 router. My problem is monitoring the connection status of the connections? Testing reachability to the MPLS router at the data center would allow bringing up the VPN, but once the VPN is up the data center router is reachable again. Is there a way to track reach ability through a specific interface?
Sent from Cisco Technical Support iPad App

[blau grana]

Hello,

I do not know about any feature which could does this. But you can configure your own workarounds, for example by configuring local PBR:

https://supportforums.cisco.com/docs/DOC-1634#Step6Optional_Configure_local_PBR

http://blog.ine.com/2008/02/13/tricks-with-local-policy-routing/

Best Regards

Please rate all helpful posts and close solved questions