Routing

Hello,So I have a problem where I know what is wrong, I just can't find a good way to fix it.See attached diagram and relevant device configs / Outputs.Scenario:Router 1 and Router 2 are iBGP peers with Router 1 acting as RR.Router 2 is connected to ...

Hi, currently router 3 has two successor path to reach Router 2  10.1.102.1/29 subnet, is there any way to view of how traffic is shared between the two links or how it switch between both link(s1/0, s1/1).I try this one { access-list 100 permit icmp...

hiI have configured Core switch with different VLANs my VLAN 80 is created for UPLINK connectivity from Firewall (10.50.1.3) I am able to access internet from VLAN 80 access ports but not able to get internet access from other VLAN please check my co...

Hello,I am planning to do unequal cost load balancing using eigrp . I have below setup.Core(6500)-------(router1)---4MB---(WAN)              \        \--------------(router2)-----6MB--(WAN)    1)Here I am planning to configure variance only to the ne...

Looking for help on on how to setup a 3825 router connecting to an isp via metro ethernet.  The public ip pool given to me by the ISP is a /26.  I would like to have my network equipment(10 3550-48 switches) on public ips and then my end users(workst...

HelloCould somebody tell me where i can find a matrix comparison and performance of the new routers ISR G2??, i would appreciate any help. Thanks,

HiI want to enable terminal monitor on always when connecting via telnet. How can i do that?Thank you

I am tasked with switching from our 7200's   to ASR1002's for IPSEC VPN connections.  Currently the 7200's run HSRP and we terminate the VPN to that address so which ever 7200 is active it run, when HSRP failover kicks in the clients drop, and re-est...

Hi,I'm facing issue with QoS which is causing TP Video Quality degradation.TelePresence is connected to L3 Switch (C3560G) where I've trusted dscp in the interface and for the uplink connecting to 6500 L2 switch I've configured trust COS. There is on...

Hi Guys,I have a 4500X VSS core in my lab ready to implement, i'm doing redundancy and failover testing at the moment, and im wondering....I have emulated an active sup failure by pulling the power plug on the active switch,now cisco does not recomme...

dearsi need your help to create 2 gre tunnels using same source interface (serial ) !the problem is the 2 tunnels aren't up when config them only one is up and the other is down

Hello,I want to check if WS-X6724-SFP and WS-X6748-GE-TX line card are in end-of-life. Hardware revision are 2.4and my provider tell me that are eol. I can not find any document about it. In fact, my provider are send me abudget to change them. The p...

Dear Experts ,We are setting up an office WAN setup  with CDMA as backup link.We are using PAP as the authentication protocal. We are not getting IP address assigned in the CDMA interface.When we give static IP address it working we can able to reach...