SNMP not responding?

[Cody Hay]

        What are the possibilites that a router's snmp would just stop working?

I have a 2811 router that was responding fine to my network management software. The router is NOT within my local network. So we had a nasty power outage where my monitoring server is so we were shut down for 24 hours. When power came back up I haven't had a poll from the router since. I have checked my configurations, changed them, reset them, cycled the router, tried different snmp software, nothing! Is it possible that my router is now just dead to SNMP?          

[InayathUlla Sharieff]

Cody,

Check the following link it might be usefull:

http://www.cisco.com/en/US/docs/ios/12_2/configfun/configuration/guide/fcf014.html#wp1001309

Regards

Inayath

[Cody Hay]

Router#show snmp

6 SNMP packets input
    0 Bad SNMP version errors
    6 Unknown community name
    0 Illegal operation for community name supplied
    0 Encoding errors
    0 Number of requested variables
    0 Number of altered variables
    0 Get-request PDUs
    0 Get-next PDUs
    0 Set-request PDUs
    0 Input queue packet drops (Maximum queue size 1000)
0 SNMP packets output
    0 Too big errors (Maximum packet size 1500)
    0 No such name errors
    0 Bad values errors
    0 General errors
    0 Response PDUs
    0 Trap PDUs

SNMP logging: enabled

I've probably sent 20 get or getnext requests. Not even showing up on the router?!