SP Services and 1900 routers

[garry cordess]

Hello,

With the G1 routers i.e. 1841 and 28xx we had the option of SP Services IOS.

Now with G2 routers i.e. 1941, 2900 and 3900 we have 3 options of software license i.e. SEC, DATA and UC.

To replace the old SP Services a Cisco data sheet is suggesting using the DATA & UC software license.

This can be done with 29xx and 39xx but where we are replacing the 1841 with a 1941 there isn't a UC option.

So how do we re-create the 1841 w/ SP Services IOS in Generation 2 routers without going to the 2900 range?

Regards,

Garry.

[Edison Ortiz]

UC license only provides VoIP gateway services, since the 1900 does not support VoIP gateway services - it makes no sense having a license for it.

Data license should be sufficient unless you are planning to use any of the security services such as IPSEC/GET VPN/DMVPN and Cisco IOS FW. If you do, then you need the Security license.

[garry cordess]

Hi Edison,

Ok, thanks for the reply. That does make sense, it was the Cisco data sheet that suggested using a combination of UC & DATA license to replace the SP Services.

As you say there isn't any VoIP support on the 1921/1941.

I will use the DATA license.

Many thanks,

Garry.