Static route and OSPF

[lumberjack91600]

Hi everybody

well that's one week i am trying to do a lab on CPT and i have a problems to join two network.

I already apologize for my bad english..

i dont what's wrong exactly i cant ping from pc1 to pc2

i put a static route on the multilayer 0.0.0.0 0.0.0.0 11.10.0.254

and i only did on the other router 2/3/4

router ospf 100

net .... ....  area 0

net .... .... area 0

cant do redistribute static on router 2 

well i dont know how to explain that easily but first i start with a basical conf.

[DSJ1]

Is the connectivity between Router 3 and Router 4  OK ?

[Giuseppe Larosa]

Hello Lumberjack91600,

>> i put a static route on the multilayer 0.0.0.0 0.0.0.0 11.10.0.254

Cisco OSPF does not support redistribution of a default static route.

On router R2 use the following:

router ospf 10

default-information originate

!

Note: you still need the default static route on the same router R2:

ip route 0.0.0.0 0.0.0.0 11.10.0.254

The default-information OSPF command injects a default route 0.0.0.0/0 if one is present in the local routing table of R2.

Once the default route is injected in OSPF by R2 as O E2 (LSA type 5) all other OSPF routers will learn it and you don't need to configure a default static route in each of them.

Hope to help

Giuseppe