cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
604
Views
3
Helpful
6
Replies

Static route redistribution into EIGRP not working...

Hello.

There already exists a redistribution mechanism to redistribute static routes through a

route-map and ACL

I thought it fine to not use this existing mechanism, but instead just create a new static route, then use command...

"# conf t
#router eigrp 1
#redistribute static metric 10000 0 255 1 1500"

When I check the neighboring router, only the static routes from the

route map + ACL mechanism

exist in its routing table.

QUESTION: Why isn't the new static route in the neighbor's routing table?

Thank you.

1 Accepted Solution

Accepted Solutions

0 <<- delay value is 0 so metric is wrong and hence the static never advertise.
you need to make it at least 100, or check interface delay and assign correct value 
check 

show eigrp

topology see if the prefix in router but not inject it in RIB or not 

View solution in original post

6 Replies 6

Hi

 The can be sent but not installed due overlaping with another route. Can you share the config from both routers?

2951 <==> 5525ASA <==> tunnel to 172.16.33.5

(obfuscated)

5525ASA#sh route
S 10.12.8.0 255.255.248.0 [1/0] via 172.16.33.5 !! not redistributed in route-map + ACL mechanism !!
S 10.13.28.0 255.255.252.0 [1/0] via 172.16.33.5
S 10.13.32.0 255.255.252.0 [1/0] via 172.16.33.5
S 10.13.36.0 255.255.252.0 [1/0] via 172.16.33.5
S 10.13.40.0 255.255.252.0 [1/0] via 172.16.33.5

---

2951#sh ip route
D EX 10.13.28.0/22
  [170/256512] via 172.16.20.5
D EX 10.13.32.0/22
  [170/256512] via 172.16.20.5
D EX 10.13.36.0/22
  [170/256512] via 172.16.20.5
D EX 10.13.40.0/22
  [170/256512] via 172.16.20.5

 

0 <<- delay value is 0 so metric is wrong and hence the static never advertise.
you need to make it at least 100, or check interface delay and assign correct value 
check 

show eigrp

topology see if the prefix in router but not inject it in RIB or not 

That solved it.

QUESTION: is the command half way down at the below link just wrong? It seems that he was taking his printouts from a real lab...

Redistribute Static Route into EIGRP in Cisco IOS Router (mustbegeek.com)

Now, after understanding all the EIGRP metrics, here’s the example of how to set the static route redistribution into EIGRP in R2:

R2#conf t
R2(config)#router eigrp 23
R2(config-router)#redistribute static metric 10000 0 255 1 1500

 

sure I will check link you share and check my note, 
in which case we use delay = 0.
I will update you 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card