05-25-2018 08:21 AM - edited 03-05-2019 10:30 AM
Hi Dear Firend I set /32 Ip on loopback interface on ASR 1002 router
Router have not any Config ACL
but when ping ip address donnot reply to me
I change IOS version Upgrade modules By romon to version 16
But problem Still Exists
Pls Help Me
05-25-2018 11:51 PM
Hello,
a few questions:
Where are you pinging from ? Can you ping the loopback locally, that is, when connected through the console ?
Post the config of your router...
05-26-2018 12:30 AM
I ping From console router CLI own Loopback Ip address
05-26-2018 12:48 AM
Hello,
so how is your loopback reachable from the outside ? Do you announce the loopback address through a routing protocol, or static routing ?
05-26-2018 03:01 AM
I set /32 255.255.255.255 subnet on loopback1
I ping from own router by console Connection
ping 192.168.1.1 source loopback1
05-26-2018 08:29 AM
hello
admin@atrinnet.net wrote:
I set /32 255.255.255.255 subnet on loopback1
I ping from own router by console Connection
ping 192.168.1.1 source loopback1
Just to confirm the below doesnt work, if so it must be a bug unless you have something netgaing it?
int lo1
ip address 192.168.1.1 255.255.255.255
no shut
ping 192.168.1.1 source loopback 1
Apply this and post out
access-list 100 permit ip host 192.168.1.1 any
access-list 100 permit ip any host 192.168.1.1
debug ip packet detail 100
debug ip icmp
ping 192.168.1.1 source loopback 1 repeat 1
res
Paul
05-26-2018 11:30 AM
There has already been a request to post the router config. I would suggest that the output of these commands might help us to identify the issue
show ip interface brief
show ip route
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide