following sw interface is not showing input/output flow of traffic.... any ideas....?
SW.ISBTHQ.ASW01#sh int gig 1/48
GigabitEthernet1/48 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet Port, address is 0022.55be.93ff (bia 0022.55be.93ff)
Description: *** GE-UTP -to- IIB103-SW01 (3750) GE-1/0/21 ***
Internet address is 10.16.101.226/30
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000-TX
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters 2w0d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
L3 in Switched: ucast: 905001834 pkt, 111623242295 bytes - mcast: 0 pkt, 0 bytes
L3 out Switched: ucast: 1743853071 pkt, 2134521654058 bytes - mcast: 0 pkt, 0 bytes
905194180 packets input, 131248097797 bytes, 0 no buffer
Received 97466 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
1744345494 packets output, 2166340540041 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
