11-23-2009 01:28 AM - edited 03-04-2019 06:46 AM
Hello everybody
Im using Cisco router as Tcp to X.25 translator. In Tcp to X.25 conversion during X.25 call setup
Cisco router acts as a XPAD device and send call request along with CUD 0X01000000 which
shows source device (Cisco Router) is a PAD device .
Our X.25 remote device just accept X.25 calls from X.25 source , not XPAD so it rejects the call.
How we can force Cisco router to act as a pure X.25 device (not PAD) or send call request without
XPAD CUD.
Thanks
11-23-2009 02:06 AM
Are you using ALP (AirLine Protocol set) or MATIP (Mainframe To IP)?
11-23-2009 04:09 AM
You can set the value that you want - cud option in translate command.
11-24-2009 04:26 AM
Hi again,
one thing more.
CUD option just adds cud string to call setup and doesn't omit it.
Nov 24 08:34:08.747: Serial0/0/2: X.25 O R1 Call (17) 8 lci 1
Nov 24 08:34:08.747: From (4): 8000 To (4): 4003
Nov 24 08:34:08.747: Facilities: (0)
Nov 24 08:34:08.751: Call User Data (8): 0x01000000 (pad)
0: 10010B44 40038000 ...D@...
8: 00010000 00746573 74 .....test
Nov 24 08:34:08.839: Serial0/0/2: X.25 I R1 Clear (5) 8 lci 1
Nov 24 08:34:08.839: Cause 0, Diag 32 (DTE originated/Packet not
allowed)
0: 100113 0020 ....
Nov 24 08:34:08.839: Serial0/0/2: X.25 O R1 Clear Confirm (3) 8 lci 1
0: 100117 ...
Thx & rgrds
11-24-2009 05:40 AM
You set the value that you want, or null.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide