Hi,
We have tunnel gre with wimax (70Mb) access and other access mpls(30Mb). We configured tunnel gre and we have problem, the tunnels are very slow both.
i show the configuration.
How we change the bandwith of the tunnel???
thanks
nterface Tunnel0
description tunel macrolan
ip address 172.30.17.49 255.255.255.252
ip ospf network point-to-point
ip ospf 1 area 0
keepalive 3 3
tunnel source 172.30.17.35
tunnel destination 10.161.128.6
end
unnel0 is up, line protocol is up
Hardware is Tunnel
Internet address is 172.30.17.49/30
MTU 17916 bytes, BW 100 Kbit/sec, DLY 50000 usec,
reliability 255/255, txload 2/255, rxload 17/255
Encapsulation TUNNEL, loopback not set
Keepalive set (3 sec), retries 3
Tunnel source 172.30.17.35, destination 10.161.128.6
Tunnel protocol/transport GRE/IP
Key disabled, sequencing disabled
Checksumming of packets disabled
Tunnel TTL 255, Fast tunneling enabled
Tunnel transport MTU 1476 bytes
Tunnel transmit bandwidth 8000 (kbps)
Tunnel receive bandwidth 8000 (kbps)
Last input 00:00:09, output 00:00:00, output hang never
Last clearing of "show interface" counters 1d04h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 639
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 7000 bits/sec, 2 packets/sec
5 minute output rate 1000 bits/sec, 1 packets/sec
641353 packets input, 351062214 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
295624 packets output, 148067207 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
