Re: Two Cisco EPC3928s in Router - Repeater mode

NenadVucetic79995 · ‎09-29-2019

Hello all,

I have a bit of a problem that I hope some of you can help me fix.

I have two Cisco EPC3928s Router/Modem units. One is my primary connection from the ISP to my PC and my Wirelesses router. Also I use built in DHCP service on it. I recently got another EPC3928s and would like to use it as a WiFI repeater.

Can this be done? And if it can, how?

Best regards.
Nenad.

paul driver · ‎09-29-2019

Hello

Looks like it possible to do - enabling WDS function on these boxes and setting the base mac address of the additional 3928 in the WDS settings of the primary 3928 <page 51 of this document>

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

NenadVucetic79995 · ‎09-29-2019

So it should find it over WiFi and connect to it? Even set the same SSID?

I will post results after I try this out.