08-28-2013 09:44 PM - edited 03-04-2019 08:53 PM
Hi Experts,
I have need to know few things.
1. I have 2 ISP's and want to use both the ISP on same time. ISP1 (5 MBPS ) ISP2 (10 MBPS ) so can I use both the ISP at same time and there is any chance to use load balancing as well ? Both the ISP is different service provider.
2. Can I use ISP1 for outgoing Traffic and ISP2 for incoming Traffic?
3. If yes so please tell me which routing protocol I have to use (default route or ospf or bgp)
4. Please share the entire configuration also.
5. I want to implement this setup as per my company requirement. So which will be best possibility both the ISP should be connected on one router or both the ISP connected to 2 different routers?
Regards
MS
08-28-2013 11:31 PM
Hi Mukesh,
I suppose you have a static route to subnet 123.12.12.3.0/24 from above output and with combination of command
ip default-network 123.12.12.105 IP address 123.12.12.106 is installed as default gateway. And is this of ISP #2?
if so it explains why it always goes only over ISP2.
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094374.shtml#flagging
Just remove from config:
no ip default-network 123.12.12.105
no ip default-gateway 123.12.12.106
Then verify routing table again:
sh ip route
Rate it
08-28-2013 11:56 PM
Hi Aman,
Thanks allot for your reply. But scenario is like below mention than what could be better option and configuration?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide