Two Tunnels One destination One router, is it possible?
Given:
1) No protocols running
2) No VRF feature
3) No Loopback Feature
4) Two difference source, WAN 1 interface and WAN2 interface
5) Destination for both IPSEC VPN tunnels are same.
6) Pre-shared key is different
7) Tunnel-1 formed, and paired with WAN-1 as source and destination IP
8) Tunnel-2 while forming gets error as same routing policy applied.
9) Need a way to create a different routing table
10) Both tunnels need to be in Active-Active mode and not in Active-Standby mode.
By how many ways it is possible to create two tunnels two tunnels in AA mode on single router/firewall.